• Home  / 
  • Blog
  •  /  Repair Tips on How to Fix Your Leaking Roof: Tips and Tricks

Repair Tips on How to Fix Your Leaking Roof: Tips and Tricks

By Brett E. / June 10, 2018

If you have observed water stains running down walls or across ceilings, the most probable cause is a leaky roof. You need to first track down the leak, which is surprisingly the only challenging part, because repairing the roof is pretty easy.

It’s important to fix a leaky roof immediately after you first spot the problem, because the moisture coming from that leak can facilitate the growth of mold, or even damage some electrical components in the house. To show you how you can go about repairing your roof, here is a comprehensive guideline on what you need to do.

Inspect for Damage Above Where the Leak Emanates

Water DamagesOn a flat roof, a leak is relatively easier to find, but sometimes the leaks will be seen a distance from the location of the actual roof damage. If the roof is slanted, look for areas higher than the point where the leak enters the home. In case of an attic, you should inspect using a flashlight to see if there are water stains or black marks of mold that could indicate water seepage.

You can have someone run a hose on sections of the roof to see where the leaks come from. It’s also a good idea to consult professional roofers like www.tampabayroofs.com for a comprehensive inspection that will reveal all areas that require repairs. While inspecting the roof, focus on identifying the following problems:

  • Look for blisters or cracks in the roofing material
  • Inspect shingles to replace damaged ones
  • Look for curled back shingles
  • Look for missing shingles

Mend Cracks and Blisters

Once you locate the blister, cut a line through the middle using a utility knife. Make sure to spare the sound roofing underneath. Soak up or squeeze out water that could be retained in the blister until this area is completely dry. Using roofing cement, spread a paste under the roofing material and press down. Along both sides of the repaired blister, drive galvanized roofing nails. Finish by covering the top with roofing cement.

Repairing Damaged Shakes

Look for damaged shakes and split them using a hammer and chisel. Remove the pieces and use a hacksaw to remove the ends of nails that cannot be pried out. Get a new shake and cut to the right size using a fine-toothed saw. Slide the shake in place and use two galvanized roofing nails to hold it in place. Use a nail set to set the heads and make sure to seal them using caulking compound.

Fixing Connections

Look for areas where different ends connect, for example the vent pipe or chimney. Inspect if the caulking is damaged then reapply where necessary. You can remove deteriorated or damaged caulking to allow the new application to bond to the flashing surface of the roof. To remove the old or loosened caulk, you need a putty knife. Make sure to first clean and dry the area before reapplying the caulk.  If you are featuring some leaks from water pipe connections, then check the pex connection tightness.

Fixing shingles

Fixing ShinglesAfter inspection, you may find several damaged shingles. These ones have to be removed and replaced with new ones. Sometimes you only need to straighten the shingles if they are curled, but it makes the work perfect to replace those that are damaged. After you have fitted the shingle, apply asphalt roof cement around the edges to seal the space.

Ensuring your roof is in perfect condition is something that will save you money in the long run and also protect your electrical fixtures. You need to conduct periodic inspections for any signs of leakages to fix the problem before it escalates. Note that working on top of a roof can be dangerous, so make sure to have the tools and watch your safety while repairing your roof.

Brett E. is the Owner of ConsumerHomeDecor.com.  Brett comes from a long line of craftsman and foreman, and has been involved with the construction and renovation world ever since he was a boy while working for his families construction and remodeling company.  After graduating with a a degree in Interior Design, Brett is the go to guy for any interior design or remodeling questions!

Click here to add a comment

Leave a comment: